- Article published at:
- Article author: Joseph Hakim
- Article tag: custom suits detroit
- Article comments count: Comments 0
The first cold snap rolls through Metro Detroit, you pull last year's overcoat out of the closet, put it on over your suit, and something is off. Your jacket sleeves poke out past the coat, the buttons strain, or the hem stops above the bottom of your suit jacket.
The problem usually isn't the coat itself. It's that the coat was sized for a sweater, not a tailored jacket. Here's how an overcoat should fit over a suit, how to check yours in a couple of minutes, and what to look for if it's time for a new one.
The short answer
An overcoat worn over a suit should be sized for the jacket underneath it. It should button without pulling, cover your suit jacket completely at the hem, cover your jacket sleeves (and your shirt cuffs), and let you move your arms freely without the suit bunching up inside. If it only fits well over a dress shirt, it's too small for business wear.
Size it over the jacket, not the shirt
This is the most common mistake. Men try on overcoats wearing a sweater, pick the size that looks trim, and discover it's tight the first time they wear it to the office.
A suit jacket adds real bulk through the chest, shoulders and arms: a lining, padding or canvas, lapels and pockets. An overcoat that's going to live on top of that needs room for it. Always try one on over a suit jacket, ideally the heaviest one you own.
If you own more than one work suit, size the coat over the heaviest jacket in the rotation. Our guide to how many suits a man needs for work covers how a small rotation holds up.
The shoulders: room for the jacket underneath
An overcoat's shoulders should sit slightly wider than your suit jacket's shoulders, enough that the coat drapes over the jacket's shoulder line instead of pressing on it.
- Too small: you can see the outline of your jacket's shoulders through the coat, or the coat's sleeve seam pulls inward and dents near the top of your arm.
- Too big: the shoulder seam hangs well past the edge of your shoulder and the coat looks borrowed.
- Right: the coat follows the jacket's shoulder cleanly with a little extra room, and you can cross your arms without the back pulling tight.
The same idea applies to your suit itself. If you're not sure your jacket's shoulders are right, start with our guide on how a suit jacket should fit in the shoulders.
The chest and buttons: close it without strain
Button the coat over your suit jacket. Then reach forward like you're grabbing a steering wheel.
- Too tight: the buttons pull and form an X of creases across the front, or the coat gapes open between the buttons.
- Right: the front lies flat when buttoned, and you can reach forward without the coat straining at the buttons or across your back.
The length: cover the jacket completely
A business overcoat should be long enough to fully cover your suit jacket. If the jacket hem peeks out below the coat, the whole look reads as mismatched, and your suit is exposed to wind, slush and road salt.
Most men do well with a coat that ends somewhere around the knee, from just above to just below it. Shorter coats look sportier; longer coats add warmth and formality but can feel like a lot if you're in and out of a car all day.
The sleeves: cover the jacket and the cuff
Your overcoat sleeves should be a little longer than your suit jacket sleeves, enough to cover both the jacket sleeve and your shirt cuff when your arms are at your sides. A good guide is a sleeve that reaches roughly to the base of your thumb.
A jacket sleeve sticking out from under the coat looks sloppy and lets cold air up your arm. Our guide to how a suit jacket sleeve should fit covers what to look for.
The two-minute mirror check
Put on your suit jacket, then your overcoat, and stand in front of a full-length mirror:
- Button the coat. Does it close flat, without pulling?
- Look at the hem. Is your suit jacket fully covered?
- Let your arms hang. Are your jacket sleeves and shirt cuffs hidden?
- Reach forward and cross your arms. Can you move without the back or armholes going tight?
Why this matters in Metro Detroit
For a lot of professionals here, winter means walking from a parking structure to the office, crossing a courthouse plaza, or heading into a client dinner in Birmingham or Troy. On those days your overcoat is the first thing people see.
That matters for executives and business owners in Metro Detroit who go from the car straight into meetings.
It's also the layer that protects your suit. A coat that covers the jacket at the hem and sleeves keeps salt spray, slush and wet weather off the garment underneath. And the weight of the cloth matters. Heavier wools and flannels are worth considering for a Michigan winter, while lighter cloth suits the shoulder seasons.
How we fit overcoats at Pearce Bespoke Detroit
We make custom overcoats made to measure, alongside the suits and sport coats they're worn over. We take more than 20 measurements, account for the jacket underneath, and talk through how and where you'll wear the coat, along with fabric weight for the season. We come to your office or home anywhere in Metro Detroit, and the first appointment takes about 90 minutes.
Production takes about four weeks, or about six if you add a custom lining. At delivery we check the fit with you, alterations are included, and every garment is backed by our perfect fit guarantee. You can see starting prices on our Pricing page.
If your coat is fighting your suit this winter, let's fix that. Book a fitting at your office or home, call 586-321-5105, or schedule a short discovery call if you'd like to talk first.
Want more fit guidance? Read how dress pants should fit and how a suit jacket should fit in the shoulders.
